BePro Spares
-
£5.00
Assioma or BePro 9mm socket.
The only difficult bit about swapping the bearings on your Assioma or BePro Favero pedals can be getting hold of a 9mm socket small anough to fit into the recess to undo the locknut.
This socket is 9mm and has a 1/4" drive to use with a socket set or torque wrench.
Remember that the end cap on both pedals has a normal thread. The locknut on the left pedal has a normal thread however the locknut on the drive side pedal is reverse threaded so you undo it clockwise and do it up anticlockwise.
The locknut should be done up to 8-10Nm
The End cap should be done up to 2-3 Nm
Learn More -
£45.00
Send your Favero BePro or Assioma back for recalibration using known weights to ensure the best accuracy for your training. We will also check and update firmware if needed. We will also check your pedal body and bearings and advise if they need replacing.
Please ensure the pedals are clean before sending or there will be an additional charge.
Quoting your order number on the package or printing out the order and including in the box the please post or courier your Pedals to:
Service
Learn More
Cyclepowermeters Limited
22 Sir Frank Whittle Business Centre
Great Central Way,
Rugby,
Warwickshire
CV21 3XH -
£22.00Cleat shims to allow correct clearance of electronics sensor on Bepro pedals. Learn More
-
£25.00Set of 6 adhesive labels for aesthetic protection of the bePRO sensor. Learn More
-
£49.00Favero bePRO replacement assembly kit Learn More
-
£22.50Favero bePRO and Assioma replacement battery charger Learn More
-
£7.50Favero bePRO and Assioma replacement USB cable USB/Micro USB Learn More
-
£7.50Favero bePRO replacement USB covers - 4 pack Learn More
-
£49.00Favero bePRO crowfoot adapter Learn More
-
£30.00Favero bePRO replacement bearing kit Learn More